Compressor Drive Shaft

A/C Compressor


Compressor Drive Shaft

Removing

- Remove compressor. Refer to=> [ Compressor, S8 10 Cylinder ].

- Remove boot - A -





- Remove driveshaft - B - from splines of drive pinion - C -

Installing

Installation is carried out in the reverse order, when doing this note the following:

- Check driveshaft - B -, splines must show no traces of wear and must be seated free of play in splines of drive wheel - C -.

- Coat the input shaft splines with Grease (G 000 100) before inserting. .

- Insert driveshaft - B - before installing compressor and slide it into drive wheel - C - up to stop.





- After installing compressor, check installation position of boot - A -.

The boot - E - is secured against slipping by the clamp on the power steering pump flange.