Operation CHARM: Car repair manuals for everyone.

Front A/C Controls






Center Console without Extension

Front A/C Controls

Removing

- Place selector lever in position "S".

- Switch off ignition.

Front ashtray, removing

- Open front ashtray.

- Operate button - arrow -.





- Pull out ashtray insert - 1 -.

- Remove bolt - 1 -.





- Pull front ashtray - 2 - out of center console.

- Disconnect electrical connector.

Remove center console panel with multimedia control unit.

- Pull center console panel with multimedia control unit - 1 - upward and off.





2 Pins
3 Spring clamp
4 Center Console

- Disconnect electrical connectors.

- Remove center console panel with multimedia control unit.

Removing front A/C controls

- Remove bolts - 1 - (Qty. 2).





- Pull front A/C controls - 3 - out of center console - 2 -.

- Disconnect electrical connectors.

- Remove front A/C controls.

Installing

Installation is reverse of removal. Observe the following when doing so:

Follow the sequence of installation when installing center console panel with multimedia control unit, front A/C controls and front ashtray:

- Connect electrical harness connectors.

- Insert front A/C controls into center console, but do not tighten bolts.

- Connect electrical harness connectors to multimedia control unit.

- Clip center console panel with multimedia control unit into center console.

- Align at center the center console panel with multimedia control unit.

- Tighten bolts of front A/C controls to the specified Tightening torque:.

- Install front ashtray => [ Front Ashtray ]. Front Ashtray

Tightening torque:s

Front A/C controls to center console: 4 Nm

Refer to the respective chapter for all other Tightening torques.