Cooler

Cooler

Removing

- Fold down center armrest and open cooler.

- Disengage retaining clips at left and right - arrow 1 -.





- Remove decorative frame on cooler - arrow 2 -, to do so the cooler lid must be closed again slightly.

- Loosen bolts - 2 - approximately 2 rotations.





- Pull out clamping pieces - 1 - over the guide.

- Open luggage compartment and fold back floor mat.

- Disconnect the electrical connector - arrow -.





- Remove cooler - 1 - from luggage compartment.

Installing

Installation is reverse of removal, noting the following:

- Bring cooler to installation position.

- Open cooler.

- Insert clamping pieces - 1 - with the bolts screwed in - 2 - into guide on cooler.





- Slide clamping pieces downward toward stop.

- Pull cooler out on to rear backrest and slide clamping pieces downward as far as possible.

- Tighten screws.

- Install decorative frame.

Tightening torque: