Multimedia Display 1 Control Module

Rear Seat Entertainment System, High Alpine

Multimedia Display 1 Control Module

• Removal and installation of Multimedia Display 1 Control Module (J744) and Multimedia Display 2 Control Module (J747) are identical.

- Switch off all electrical consumers.

- Remove the key.

Removing

- Remove the luggage compartment trim panel on the left side.

- Remove the screw - 3 - (3 Nm).





- Remove the navigation system with CD drive control module (J401) with the mounting frame - 2 -. Refer to => [ Navigation System with CD Drive Control Module ] Removal and Replacement.

- Remove Multimedia Signal Splitter (R181) - 1 -. Refer to => [ Multimedia Signal Splitter ]. Multimedia Signal Splitter

- Remove nuts - 4 - (front and rear), - 6 - and - 7 - (3 Nm).

- Carefully pull mounting frame - 5 - out of installation recess and disconnect harness connectors to vehicle wiring harness.

- Remove both bolts - arrows - (2 Nm) on underside of mounting frame.





- Remove both bolts - arrows - (2 Nm) on upper side.





- Carefully swivel multimedia display 1 control module - 2 - out of mounting frame - 1 - and disconnect electrical connections.

Identify the harness connections to assist the installation.

Installing

- Install in reverse order of removal.