Rear Cross Panel Trim

Trim

Rear Cross Panel Trim





1 - Rear cross panel trim

• Removing

- Pry out upper part - 4 - or spreader clips - 3 - (Qty. 3) using a flat-head screwdriver.

- Remove spreader clips - 3 - (Qty. 3).

- Pull out rear cross panel trim - 1 - upward and unclip clips - 2 - when doing this.

• Installing

Installation is reverse of removal. Observe the following when doing so:

• Replace damaged clips - 2 - and spreader clips - 3 - as well as upper parts - 4 -.

• Side tabs on rear cross panel trim must be located in recesses of the rear cross panel trim.

• After assembling trim, make sure seal is properly fitted.

2 - Clips (Qty. 4)

• Replace if damaged

3 - Spreader clips (Qty. 3)

• Replace if damaged

4 - Upper part (Qty. 3)

• for spreader clip

• Replace if damaged

5 - Striker pin cover