Operation CHARM: Car repair manuals for everyone.

Seat






Power Memory Front Seats

Seat

Before disconnecting battery: Obtain radio code.

To remove the driver's seat: Move steering wheel all the way forward and up.

If backrest covers are to be removed on the comfort seat, move backrest head adjustment forward.

Move height adjustment and seat angle adjustment completely up and backrest to a 90° position.

CAUTION!
On vehicles equipped with Audi Telematics by OnStar, switch-off emergency (back-up) battery for Telematic/Telephone Control Module prior to disconnecting vehicle battery. Switch-on emergency (back-up) battery after reconnecting vehicle battery





1 - Front seat

Removing

- Remove anchorage point for outer floor assembly => [ Outside Floor Assembly Anchorage Point ] Removal and Replacement.

- Guide belt strap out of side panel.

- Remove front seat rail covers. Front Seat Rail Cover

- Remove rear seat rail covers. Rear Seat Rail Cover

- Push front seat - 1 - fully upward and to the rear.

- Remove rear bolts - 2 - (Qty. 2).

- Move seat forward.

- Remove front bolts - 2 - (Qty. 2).

CAUTION!
Before removing seat: Disconnect the battery ground strap.

- Tip front seat - 1 - back.

Before disconnecting the ignition and ground wiring, discharge static electricity by touching the door striker pin.



- Disconnect airbag connector - 6 - => [ Side Airbag, Disconnecting ] Procedures.

- Disconnect power supply connector - 5 -.

- Disconnect seat heater connector - 4 -.

- Connect airbag adapter => [ Airbag Adapter VAS 6229, Connecting ] Testing and Inspection.

- With help from a second mechanic, lift front seat - 1 - out of vehicle.

Installing

- Installation is reverse of removal.

- USA vehicles: make sure bump stop is fitted at front passengers seat => [ Front Passenger Seat Stop ] Front Passenger Seat Stop.

- Switch on ignition.

CAUTION!
No one should be in vehicle when connecting battery.

- Connect battery ground strap.

2 - Screws (Qty. 4)

Tightening torque: 40 Nm

3 - Connector (black) for the seat forward/back adjustment motor, seat height adjustment motor and seat angle adjustment motor emergency power supply

4 - Connector for heated seat (gray)

5 - Current supply connector (red)

6 - Connector for airbag (yellow)