Routing of Wiring on Engine
Routing of Wiring on Engine
1 Heat insulation sleeve
• Attach to Camshaft Position (CMP) Sensor 4 (G301)
2 Electrical harnesses for camshaft adjusters
• Clip into retaining clips
3 Cable tie with clip
• Clip into hole of bracket
4 Retaining clip
• Tighten to 9 Nm
5 Ground wire
• Tighten to 9 Nm
6 Cable tie for oxygen sensor harnesses
• Secure on the wires to ignition coils for cylinders 1 to 3 and 4 to 6
7 Cable tie for oxygen sensor harnesses
• Clip into hole of bracket
8 Retaining clip
• Tighten to 9 Nm
9 Electrical harnesses for camshaft adjusters
• Clip into retaining clips
10 Heat insulation sleeve
• Attach to Camshaft Position (CMP) Sensor 3 (G300)
11 Harness clip
• Clip into holes
12 Ground (GND) wire
• Tighten to 9 Nm