Operation CHARM: Car repair manuals for everyone.

Belt Pulley Version 2






Belt Pulley Version 2

Different versions of the pulley are installed, depending on compressor construction type and engine version. .

Pulley, removing from compressor and re-installing, refer to => [ Compressor Pulley, Version 2 ] Service and Repair

Belt pulley version "2" is installed on compressor types " 6 SEU 14" and "7 SEU 17".





1 Circlip

Remove carefully using a small screwdriver or needle-nose pliers (especially note belt pulley when doing this)

Removing and installing, refer to => [ Compressor Pulley, Version 2 ] Service and Repair

As of model year 2006, circlips with a rubber disc vulcanized on to them are installed as a running change, this rubber disc replaces the plastic disc which could be glued on up to then not present on all compressors. Refer to => [ Compressor Pulley, Version 2 ] Service and Repair

2 Drive plate

Attached to compressor input shaft

Different versions,

With overload safeguard, triggers when torque is too-high compressor produces friction and belt pulley runs freely without driving the compressor.

Removing and installing, refer to => [ Compressor Pulley, Version 2 ] Service and Repair

Tightening specification 35 Nm

A plastic washer may be glued on, depending on time period of production. Refer to => [ Compressor Pulley, Version 2 ] Service and Repair.

3 Circlip

Replace

Install on proper side (level side to compressor)

Removing and installing, refer to => [ Compressor Pulley, Version 2 ] Service and Repair

4 Spacer

Dimensions: 17.5 x 10 x 3 mm

5 Rubber element

6x, install on proper side. Refer to => [ Compressor Pulley, Version 2 ] Service and Repair

Decouples belt pulley from compressor driveshaft, damps vibrations and noise.

for installation, lightly coat rubber elements, with tire mounting paste or a soap solution as a lubricant

6 Belt pulley

Belt pulley is made of plastic and is sensitive to impact, therefore handle it with especial care

Different versions,

Removing and installing => [ Compressor Pulley, Version 2 ] Service and Repair

7 Compressor

Different versions are installed, depending on engine version and country version of vehicle.

Clean compressor flange before sliding on pulley.