Collision Avoidance Module: Service and Repair

Lane Change Assistance Control Modules

Removing





- Remove rear bumper cover.

- Disconnect electrical connector - 3 -.

- Remove bolts - 2 - and - 4 -.

- Remove the lane change assist control module - 1 - from the mount on the bumper - arrow -.

Installing

Install in reverse order of removal, observing the following:

- Install rear bumper cover.

Lane Change Assistance Control Module (J769)/ (J770) must be re-calibrated each time bumper cover is removed. Refer to=> [ Lane Change Assistance, Preparing for Calibration ] Lane Change Assistance, Preparing for Calibration.