Trim, Tunnel Side

Trim, Tunnel Side

Special tools, testers and auxiliary items required

• Engine and Gearbox Support (VAS6095)

• Seat Repair Stand (VAS6136)

Removing


Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components General Safety Precautions ] .

- Switch the ignition on.

- Disconnect the battery ground cable with the ignition switched on.

- Remove the front seat. Refer to => [ Front Seat ] Front Seat.

- Mount the (VAS 6136) on the (VAS 6095).

- Attach the seat to the (VAS 6136).

- Disengage fastening strip - 1 - on footwell cover - 2 - from brackets - 4 - (quantity: 2) on trim - 3 -.






- Remove expanding rivets - 4 - (quantity: 2).






1. Retaining strip

2. Footwell cover

3. Trim


- Disengage trim panel - 1 - in backrest and belt anchor area.






- Remove trim panel - 1 - upward.

Installing


Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components General Safety Precautions ] .

Install in reverse order of removal. Note the following:


Before handling airbag units (for example, when disconnecting the harness connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Ensure airbag connector (yellow) engages correctly.

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.


Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. Maintain personal safety when connecting the battery by staying out of airbag deployment areas, keeping a distance from belt tensioners/seat belts and ensuring no other people are in the vehicle interior at the moment when the battery is connected.

- Switch on ignition.

- Connect the battery ground cable with the ignition turned on.

- If the Airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle diagnostic tester.