Compressor Input Shaft

Compressor Input Shaft

Removing

- Remove compressor, refer to => [ Compressor ] Compressor.

- Remove boot - A -






- Remove driveshaft - B - from splines of drive pinion - C -

• Currently, the boot - A - is secured against slipping by a clamp on flange of drive toothed gear - C - of engine.

Installing

Installation is carried out in the reverse order while noting the following:

- Check driveshaft - B -, splines must show no traces of wear and must be seated free of play in splines of drive wheel - C -.

- Coat the driveshaft splines - B - with grease (G 000 100) before inserting. Refer to the Electronic Parts Catalog.

- Insert driveshaft - B - before installing compressor and slide it into drive wheel - C - up to stop.






- After installing compressor, check installation position of boot - A -.

The boot - E - is secured against slipping by the clamp on the power steering pump flange. Refer to the Electronic Parts Catalog.