Brake Lamp Sensor

Brake Lamp Sensor

• The vehicle may have a brake lamp sensor depending on the model.

• After removing, the brake lamp sensor can be reused.

• The brake light sensor programs itself. It is not necessary to calibrate it after installation.

- Remove the driver side trim panel..

Removing

- Separate the electrical connection.

- Press the brake light sensor plunger all the way in.

- With the plunger pressed in, rotate the colored piece on the brake light sensor left as far as the stop to release the switch.

• The plunger must remained pressed in when releasing the brake light sensor.

- Let go of the brake light sensor plunger after releasing.

- Insert a (T40168 A) between the brake light sensor plunger and the brake pedal.

• The cone on the tool must face in the direction of the driver seat. The opening on the tool must align with the bulge on the brake light sensor.

- Press the (T40168 A) against the brake lamp sensor. This releases the three retaining tabs on the brake lamp sensor.

- Remove the brake lamp sensor from the mount.

installing

• When installing the brake lamp sensor, the plunger adjusts itself automatically.

• The brake pedal must remain in end position during installation and must not be moved.

• The brake pedal must be connected with the brake booster.

- Insert the brake lamp sensor in the mount on the brake pedal and press it in lightly.

• The brake lamp sensor must engage audibly with all three retaining tabs.

• The switch must not be rotated in the mount on the brake pedal.

• When installing the brake lamp sensor, the plunger adjusts itself automatically.

- Rotate the colored piece on the brake lamp sensor to the right as far as the stop to secure the switch.

- Connect the electrical connector.

- Install the trim on the driver side..

• Check the brake lamp sensor function after installing it and before driving.