Adaptive Cruise Control Sensor (G550)

Adaptive Cruise Control Sensor (G550)

The adaptive cruise control sensor is located behind the license plate holder in the front bumper.

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)

Removing

• Due to limited space, it is necessary to remove the bolts from the bumper cover and to pull bumper cover forward slightly when removing and installing.

- Remove the lock carrier cover - 1 -.






- Remove bolts - 2 -.

- Remove license plate holder - 3 -.

- First release connector - 1 - and then remove.






- Rotate fasteners - 2 - approximately 45° left and remove.

- Remove the adaptive cruise control sensor forward through the bumper cover.

- Remove bolts - 2 -.






- Remove bracket upward and out between bumper and bumper cover.

Installing

Install in reverse order of removal. Note the following:

• Studs in bracket are preset. If necessary, correct adjustment.

- Place the adaptive cruise control sensor on a soft, clean cloth.

Measure Dimension - a - of all Studs.





Dimension - a - must be 43 mm.

- Insert bracket and tighten bolts.

Tightening specification, refer to => [ Adaptive Cruise Control Sensor (G550) Overview ] Service and Repair

- Install the adaptive cruise control sensor and carefully push the mounts onto the stud bolts inside the sensor.

- Install front bumper cover license plate holder and tighten screws.

- Calibrate the adaptive cruise control. Refer to => [ Adjustment Procedure using ] Adjustment Procedure Using ACC Setting Device (VAS 6190).