Ground Cable With Battery Monitoring Control Module (J367), From MY 09

Ground Cable with Battery Monitoring Control Module (J367), From MY 09

Special tools, testers and auxiliary items required

• Pry Lever (80 - 200)

Removing

- Switch off ignition and remove ignition key.

TDI (SCR) vehicles

• After the ignition is switched off, the reducing agent goes from the metering line to the Reducing agent injector (N474) and back into the reducing agent active chamber.

• Wait until all the reducing agent has been returned before working in this area. This could take up to 10 minutes after switching off the ignition.

• Only after this is complete can the battery be disconnected. Again, this could take up to 10 minutes after switching off the ignition.

- Remove screw - 2 - and pull floor vent - 1 - up.






- Remove the cover on the rear seat rail.

- Open the rear clips - 1 - - arrow -.






• Use a screwdriver is necessary to remove the clips.

- Release retaining clamps on back side of cover - 1 - in - direction of arrow A -.






• The seat is not shown in the illustration.

- Then remove cover in - direction of arrow B - from driver's seat console.

- Pry the covers - 1 - and - 3 - out of floor covering using the (80 - 200).






- Remove both front screws - 4 - on driver's seat console and tip console - 2 - up.

- Free up the wiring harness for the driver seat.

• The seat is not shown in the illustration.

- Move the backrest and the seat surface forward with the driver seat folded.






- Remove cover - 2 - over battery by releasing retaining clamps - 1 - - arrow -.

• Use a screwdriver is necessary to remove the clips.

- Loosen the nut several turns and remove the ground wire terminal clamp - 4 - from the battery terminal.






- Disconnect the electrical connector - 6 -.

- Remove the nut - 3 - and remove the ground cable - 2 - and grommet - 1 - out of the battery tray.

- Remove the Battery monitoring control module (J367) - item 5 -.

Installing






Install in reverse order of removal, observing the following:

• If the connector on the battery monitoring control module comes loosen when connecting the battery, wait 30 seconds before connecting it again.

- Attach the ground cable battery terminal to the ground point and tighten the nut.

- Connect the ground wire terminal clamp 1 by hand to the battery negative terminal - and tighten the nut.

- Wait 30 seconds and then connect the connector to the battery monitoring control module.

- Install the bracket for the driver seat.

- Follow the instructions after connecting the battery. Refer to => [ Connecting ] Battery, Disconnecting and Connecting.

Tightening Specifications