Cooler J698

Cooler J698

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Removing






- Fold the center armrest - 3 - upward.

- Open the cover - 1 - above the cupholders.

- Remove the trim - 2 - using the (3409).

- Pry the caps - 4 - off the screws.






- Remove screws - 1, 3, 5 -.

- Pry the cooler - item 2 - out of the multi-box using the (3409) - arrows -.








Danger of damaging the compressor, the refrigerant lines and the cooler.

• Do not bend the coolant lines and hoses between the compressor and cooler.

- Carefully push the cooler to the right - arrow - until the hinge bolts are accessible.

- Remove the bolts - 1 - and - 2 -.

- Pull the cooler and compressor a little bit to the rear - arrow - and disconnect the connect - 1 -.






- Carefully remove the cooler - 2 - and compressor - 3 - from the multi-box.

Installing






Installation is reverse of removal, noting the following:

- Make sure the edge protectors - 2 - and - 3 - are installed - 1 -.

- Install the cooler and compressor into the multi-fox and connect the connector - 4 -.

- Mount the compressor on the edge protector and tighten the screws.

• The cooler must move easily.

• If it is not easy to move the compressor, then pull it out just far enough so that the edge protector can be mounted on the multi-box mount.

- Push the cooler (J698) into the multi-box until the retaining clamps engage audibly.

Tightening specifications, refer to => [ Cooler Overview ] Cooler Overview.