Trim

Trim

Removing

- Bring left seat into service position. Refer to => [ Driver Seat, Bringing Into Service Position ] Driver Seat, Bringing Into Service Position.

- Switch off the ignition.

- Remove assembly cover => [ Assembly Cover ] Assembly Cover.

- Remove screws - 2 - from trim panel - 1 -.






- Press tabs - 1 - (quantity: 4) in - direction of arrow - and unclip trim panel - 2 - in front area.






- Pull off trim - 2 - as far as the switch wires allow.

- Disconnect connector - 1 - at Driver Seat Lumbar Support Adjustment Switch (E176) - 2 -.






- Disconnect connectors - 3 - and - 5 - from housing - 4 -.

The following switches are installed in the housing - 4 -:

• Seat Fore/Aft Adjustment Button (E418)

• Inclination Adjustment Button (E421)

• Seat Height Adjustment Button (E424)

• Backrest Adjustment Button (E425)

- Remove the trim.

Installation

Install in reverse order of removal. Note the following:

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.

Tightening specifications, refer to => [ Sill and Tunnel Side Trim Panels ] Sill and Tunnel Side Trim Panels and => [ Driver Seat Bracket Assembly Overview ] Driver Seat Bracket Assembly Overview