Body - Noises From The Panorama Sunroof
60 Panorama sunroof noisy60 10 05
2018898/5
May 6, 2010
Supersedes Technical Service Bulletin Group 60 number 09-10 dated September 9, 2009 for reasons listed below.
Affected Vehicles
Condition
Wind noises from the sunroof or noises when opening or closing panorama sunroof.
Technical Background
Adjustment of sunroof cover may be necessary. The following detailed adjustment instructions are in addition to the repair manual.
Production Solution
Changed production process to ensure correct adjustment.
Service
1. Clear the sunroof area of any debris before opening or adjusting panels. This will prevent any debris from falling onto the rails.
2. Measure the dimensions at several points on each of the three sunroof panels (front panel, middle panel, and rear panel).
Adjust the panels if necessary.
The gaps, labeled in Figure 1, should measure as listed below (in mm):
A = -1.2 +/- 0.5
B = 0 +/- 0.5
C = -0.6 +/- 0.5
D = 0.4 +/- 0.5
E = 10
F = 1.5
G = 1.5
H = 11
The gap labeled A in Figure 2 should measure 11 mm.
To avoid tension in the glass panel, tighten the screws in sequence depicted in Figure 3.
Warranty
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.