Seat Frames

Headrest Guide

Removal

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

- Remove seat:

• Manual seats, refer to => [ Seat ] Manual Seats.

• Power seat, refer to => [ Seat ] Power Seats.

- Secure the seat on the (VAS 6136) => [ Installing Seat On VAS 6136 ] Installing Seat on VAS 6136.

- Remove the headrests, refer to => [ Headrests with Locking Mechanism ]. Headrests With Locking Mechanism

- Remove backrest cover panel, refer to => [ Backrest Cover ]. Backrest Cover

- Remove cover with upholstery, refer to => [ Backrest Cover and Upholstery ] Seat Covers and Upholstery.

Headrest Guide without Release Button

- Press retaining tab - arrow - on headrest guide - 1 - toward center of headrest guide.

- Hold the retaining tabs down.

- Pull the headrest guide up out of the backrest frame - 2 -.

Installation

Installation is reverse of removal, but note the following:

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

• Ensure that electrical connections are pushed in as far as stop and engage with a click.

• Make sure the retaining tab engages correctly in the backrest frame.

- Switch on ignition.

CAUTION!
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.