Seat Rail Cover

Seat Rail Cover

• The removal and installation procedure for the seat rail covers describes the driver seat rail on the sill side. The procedure for the cover on the tunnel side is similar.

Removal





CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

- Remove seat:

• Manual seats, refer to => [ Seat ] Manual Seats.

• Power seat, refer to => [ Seat ] Power Seats.

- Unclip the retaining tabs - 3, 4 and 5 - on the cover - 1 - from the seat rail - 2 -.

- Remove cover - 1 - forward, preferably parallel to seat rail.

Installation

Installation is reverse of removal, but note the following:

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

• Ensure that electrical connections are pushed in as far as stop and engage with a click.

- Switch on ignition.

CAUTION!
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.