Seat Pan

Seat Pan

• Removal and installation is the same on the driver and passenger seat.

Removal

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

- Remove the seat. Refer to => [ Seat ]. Seat

- Secure the seat on the (VAS 6136). Refer to => [ Installing Seat On VAS 6136 ] Installing Seat on VAS 6136.

- Remove the backrest. Refer to => [ Backrest ]. Backrest

- Remove cover with upholstery from seat pan. Refer to => [ Seat Pan Cover and Upholstery ] Seat Covers and Upholstery.

Installation

Further installation is performed in reverse sequence of removal, but observe the following:

- Install removed cover with upholstery in new seat pan.

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

• Ensure that electrical connections are pushed in as far as stop and engage with a click.

- Switch on ignition.

CAUTION!
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.