Backrest End Switch

Backrest End Switch

Removal





CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

- Remove the backrest. Refer to => [ Backrest ]. Backrest

- Remove backrest cover panel. Refer to => [ Backrest Cover ] All Seats.

- Disconnect the electrical connector - 1 - from the coupling - 2 -.

- Remove the coupling upward from the mount on the housing - 3 -.

- Clip on housing cover - 1 -.





- Remove the backrest stop switch - 2 - with the wire and coupling from the housing.

• The two stop switches in the housing must not be separated and can only be replaced together with wire and coupling.

Installation

Installation is reverse of removal, but note the following:

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

• Ensure that electrical connections are pushed in as far as stop and engage with a click.

- Switch on ignition.

CAUTION!
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.