Lumbar Support Adjustment Switch

Lumbar Support Adjustment Switch

• Removal and installation is the same on the driver and passenger seat.

Removal





- Remove tunnel side trim panel. Refer to => [ Sill Side Trim ]. Sill Side Trim

- Disconnect electrical harness connector - 4 -.

- Remove the bolts - 2 -.

- Remove the lumbar support adjustment switch - 3 - from the trim - 1 -.

Installation

To install, perform the steps used in removal in reverse order.

Tightening specifications, refer to => [ Lumbar Support Adjustment Switch Assembly Overview ] Power Seats.