Seat Angle Adjustment Motor

Seat Angle Adjustment Motor

Removal

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

- Remove the seat. Refer to => [ Seat ]. Seat

- Secure the seat on the (VAS 6136). Refer to => [ Installing Seat On VAS 6136 ] Installing Seat on VAS 6136.

- Remove the bolts - 2 -.





- Remove the bolt - 3 -.

- Disconnect electrical harness connector - 4 -.

- Remove the seat angle adjustment motor - 1 -.

Installation

Installation is reverse of removal, but note the following:

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

• Ensure that electrical connections are pushed in as far as stop and engage with a click.

- Switch on ignition.

CAUTION!
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

Tightening specifications, refer to => [ Seat Angle Adjustment Motor Assembly Overview ] Power Seats.