Navigation System

Navigation System with CD Drive Control Module Multi-Pin Connector Assignments





1 Multi-Pin Connector, Gray, 32-pin (T32f) from the Rear View Camera System Control Module (J772)/External Audio Source Connection (R199)

2 GPS connection (blue) from Navigation System Antenna (R50)

3 Connection block with four multi-pin connectors

4 IF connector (white) to the Antenna Selection Control Module (J515)

5 HF connector (white) from the Antenna Selection Control Module (J515)

• Unlisted connector terminals are not used.

1 - Multi-Pin Connector, Gray 32-pin (T32f)





6 Right LF-In from the External Audio Source Connection (R199)
14 Screen ground from the Rear View Camera System Control Module (J772)
15 Sync. video input from the rear view camera system control module
16 Video input green from the rear view camera system control module
21 LF-In ground from the external audio source connection
22 Left LF-In from the external audio source connection
30 Video ground from the rear view camera system control module
31 Video input blue from the rear view camera system control module
32 Video input red from the rear view camera system control module

A - Multi-Pin Connector, 8-pin





2 Right front speaker (+) (not used)
3 Left front speaker (+) (not used)
6 Right front speaker (-) (not used)
7 Left front speaker (-) (not used)

B - Multi-Pin Connector, Black 12-pin (T12i)





1. Not used

2. Signal ground to CD Changer (R41)/Satellite Radio (R146)

3. Speed signal (not used)

4. Permanent positive to CD Changer

5. K diagnostic (not used)

6. CD data out to CD Changer

7. BOSE coding (not used)

8. Left signal from CD Changer/Satellite Radio

9. Right signal from CD Changer/Satellite Radio

10. Positive switched to CD Changer

11. CD data in from CD Changer

12. CD CLK from v

C - Multi-Pin Connector, Black 12-pin (T12k)





1. Microphone input (-) (not used)

2. Back-up light signal from the Vehicle Electrical System Control Module (J519)

3. Left front signal (+) to Digital Sound System Control Module (J525)

4. Microphone output (-) (not used)

5. Left rear signal (+) to digital sound system control module

6. LF (-) from Telephone Transceiver (R36)

7. Microphone input (+) (not used)

8. Signal ground to (all -) to the digital sound system control module

9. Right front signal (+) to digital sound system control module

10. Microphone output (+) (not used)

11. Right rear signal (+) to digital sound system control module

12. LF (+) from Telephone Transceiver

D - Multi-Pin Connector, Black 8-pin (T8d)





9 CAN-Bus High (Infotainment)
10 CAN-Bus Low (Infotainment)
11 LF mute, not used
12 Terminal 31
13 Positive switched to Digital Sound System Control Module (J525)
14 Anti-theft warning system (not used)
15 Terminal 30
16 Permanent positive (not used)