Front Axle Camber, Adjusting

Front Axle Camber, Adjusting

- Removing and installing the center underbody trim.

- Remove and install the front underbody trim.

- If installed, remove and install the right front tire pressure monitoring antenna (R60) with the bracket. Refer to => [ Tire Pressure Monitoring Antenna ] Service and Repair.

- Remove the lower transverse link to retaining bracket connection nut - A - and loosely install new nut.





- Adjust camber by turning eccentric bolt - B -.

• The maximum adjustment range is 90° to left or right of center position.

- Tighten nut - A -.

- Tightening specifications, refer to => [ Lower Transverse Link with Retaining Bracket, Stabilizer Bar, Coupling Rod and Level Control System Sensor Assembly Overview ] Lower Transverse Link With Retaining Bracket, Stabilizer Bar, Coupling Rod and Level Control System Sensor Assembly Overview.

- After tightening nut - A -, check camber value once more. Refer to => [ Vehicle Alignment Specified Values, All Wheel Drive ] [1][2]Alignment Specifications.

• If adjustments have been made on the front axle, perform a zero adjustment on the steering angle sensor (G85) using the Vehicle Diagnostic, Testing and Information System (VAS 5051B).