Rear Axle Camber, Adjusting

Rear Axle Camber, Adjusting

- Remove and install the rear noise insulation.

- Remove and install the front noise insulation.

- If installed, remove and install the right rear tire pressure monitoring antenna (R62) with the bracket. Refer to => [ Tire Pressure Monitoring Antenna ] Service and Repair.

- Remove the lower transverse link to retaining bracket connection nut - A - and loosely install new nut.





- Adjust camber by turning eccentric bolt - B -.

• The maximum adjustment range is 90° to left or right of center position.

- Tighten nut - A -.

- Tightening specifications, refer to => [ Lower Transverse Link with Retaining Bracket and Tie Rod Assembly Overview ] Lower Transverse Link With Retaining Bracket and Tie Rod Assembly Overview.

- After tightening nut - A -, check camber value once more. Refer to => [ Vehicle Alignment Specified Values, All Wheel Drive ] [1][2]Alignment Specifications.