Rear Axle Toe, Adjusting

Rear Axle Toe, Adjusting

- Remove and install the rear noise insulation.

- Remove the lower transverse link to retaining bracket connection nut - C - and loosely install new nut.





- Adjust the toe by the turning eccentric bolt - D -.

• The maximum adjustment range is 90° to left or right of center position.

- Tighten the nut - C -.

- Tightening specifications, refer to => [ Lower Transverse Link with Retaining Bracket and Tie Rod Assembly Overview ] Lower Transverse Link With Retaining Bracket and Tie Rod Assembly Overview.

- After tightening the nut - C -, check the toe and camber values again. Refer to => [ Vehicle Alignment Specified Values, All Wheel Drive ] [1][2]Alignment Specifications.