Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2008 >> R8 Quattro Coupe (423) V8-4.2L (BYH) >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Relays and Modules - Transmission and Drivetrain >> Relays and Modules - ASMT >> Control Module >> Service and Repair >> Selector Lever Sensor System Control Module, R Tronic

Selector Lever Sensor System Control Module, R Tronic






Selector Lever Sensor System Control Module, R Tronic

Removing

- Remove shift mechanism. Refer to => [ Selector Mechanism, R Tronic ] .





- Disconnect the three electrical connectors to the Selector Lever Sensor System Control Module (J587).





• Disconnect the electrical connector - 5 - to the Transmission Control Module (J217).

• Electrical connector - 6 - to the Sport Program Button (E541)

• Electrical connector - 7 - to the Selector Lever Transmission Range Display (Y5)

- Remove all 6 bolts - 4 -.

- Remove the Selector Lever Sensor System Control Module (J587) - 3 - from the shift mechanism housing - 1 -.

Installing

• Tightening specifications. Refer to => [ Selector Mechanism, R Tronic Assembly Overview ] .

• Use the shift mechanism housing grease.

Install in reverse order, paying attention to the following:

- Grease the roller bearing - 2 - lightly and make sure it is seated securely in the selector lever.

- Check the O-ring => [ (Item 14) O-ring ] on the bottom end of the selector lever rod and grease it lightly.

• The magnet on the bottom end of the selector lever rod (the O-ring => [ (Item 14) O-ring ] is installed on it) must be installed securely.

- Check the magnet, for example, with a bolt.

- Remove metal shavings or other metallic objects from the magnets.

• The magnet transmits the selector lever position or shift procedure to the Selector Lever Sensor System Control Module (J587).

• Shifting is not possible without the magnet or the Selector Lever Sensor System Control Module (J587) cannot recognize the shifting procedure.

- When connecting the Selector Lever Sensor System Control Module (J587), make sure the roller bearing engages correctly.

- Tighten bolt - 4 -.

- Guide the three electrical connectors on the Selector Lever Sensor System Control Module (J587) through the opening on the shift mechanism housing and connect them.

• Disconnect the electrical connector - 5 - to the Transmission Control Module (J217).

• Electrical connector - 6 - to the Sport Program Button (E541)

• Electrical connector - 7 - to the Selector Lever Transmission Range Display (Y5)
pro multis · About Operation CHARM