Lower Transverse Link With Retaining Bracket, Stabilizer Bar, Coupling Rod and Level Control System Sensor Assembly Overview

Lower Transverse Link with Retaining Bracket, Stabilizer Bar, Coupling Rod and Level Control System Sensor Assembly Overview





1 Clamp

2 Bolt

• 30 Nm

3 Bolt

4 Bolt

• 30 Nm

5 Retaining Bracket

6 Retaining Bracket

7 Bolt

• 30 Nm

8 Nut

• Pre-tighten with 8 Nm and tighten with final tightening torque in curb weight position.

• 110 Nm

• Always replace after removal.

• Must be tightened in the curb weight position. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] Front Suspension.

9 Nut

• Pre-tighten with 8 Nm and tighten with final tightening torque in curb weight position.

• 110 Nm

• Always replace after removal.

• Must be tightened in the curb weight position. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] Front Suspension.

10 Eccentric Washer

11 Retaining Bracket

12 Bolt

• 30 Nm

13 Eccentric Bolt

• For camber setting.

14 Bonded Rubber Bearing

• Note the installation position.

• Replacing, refer to => [ Lower Transverse Link Bonded Rubber Bearing ] Lower Transverse Link Bonded Rubber Bearing.

15 Left Front Level Control System Sensor (G78) or Right Front Level Control Sensor (G289)

• Removing and installing, refer to => [ Level Control System Sensor ] Front Suspension.

16 Ball Pins to the Lower Transverse Link

• 8 Nm

17 Bolt

• 8 Nm

18 Lower Transverse Link

• Removing and installing, refer to => [ Lower Transverse Link with Retaining Bracket ] Lower Transverse Link With Retaining Bracket.

19 Nut

• 110 Nm

• Always replace after removal.

• After loosening the threaded connection of the lower transverse link to the wheel bearing housing, adhesive residue on the pin thread must be removed.

20 Wheel Bearing Housing

21 Bolt

• 8 Nm

22 Air Guide for Brake Cooling

• Installed in the V10 gasoline engine.

23 Bolt

• 60 Nm

• Must be tightened in the curb weight position. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] Front Suspension.

24 Bolt

• 8 Nm

25 Coupling Rod

• Removing and installing, refer to => [ Coupling Rod ] Coupling Rod.

26 Bolt

• 60 Nm

• Must be tightened in the curb weight position. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] Front Suspension.

27 Stabilizer Bar

• Removing and installing, refer to => [ Stabilizer Bar ] Stabilizer Bar.

28 Rubber Bushing

• When installing, the rubber bushing opening must face up.

• The stabilizer bar and rubber bushing must be free of grease when installing.

29 Stabilizer Bar Mount