Transmission Control Module

Transmission Control Module

Removing

- Remove the rear shelf.

- Disconnect electrical connectors - 1 - and - 2 - on the Transmission Control Module (J217).





- Remove the nuts - arrows - and the Transmission Control Module (J217).

Installing

Install in reverse order, paying attention to the following:

- Install the rear shelf.

If "update programming" was performed on the Transmission Control Module (J217) or the module was replaced:

- Perform clutch basic setting. Refer to => [ Clutch Basic Setting, R Tronic ] Programming and Relearning.

- Perform gear selector basic setting. Refer to => [ Gear Selector Basic Setting ] Testing and Inspection.

Tightening Specifications