Clutch Position Sensor: Service and Repair

Clutch Position Sensor, R Tronic

Special tools, testers and auxiliary items required

• Puller (T10055)

Removing

• Transmission removed.

- Free up the electrical connector with wire - arrow - on the bracket - 1 -.





- Remove bolts - arrows -.





- Remove the Clutch Position Sensor (G476) with bracket - 1 - from the centering pins using the Puller (T10055).

- Remove the bolts - arrows - and the Clutch Position Sensor (G476) - 1 - from the bracket - 2 -.





Installing

• Tightening specifications. Refer to => [ R Tronic Clutch Release Mechanism Assembly Overview ] .

Install in reverse order, paying attention to the following:

- Secure the Clutch Position Sensor (G476) - 1 - on the bracket - 2 - with both bolts - arrows -.

- Guide the Clutch Position Sensor (G476) wire through the opening on the transmission from below.

- Carefully press the Clutch Position Sensor (G476) with the bracket onto the centering pins on the transmission.

• The two centering pins must be inside the transmission. Install them into the holes inside the transmission if necessary.

- Tighten the bracket by hand first and then to the tightening specification on the transmission.

- Install the transmission.