Front Bumper Assembly Overview, RS4
Front Bumper Assembly Overview, RS4
• Removal and installation is done the same as the standard bumper from model year 2006.
• Only differing steps are described.
1 Screw
• 6 Nm
2 Bumper cover
• Removal and installation as with standard production.
• While installing, the following sequence described for assembling/bolting must be observed for correct assembly.
- Set cover onto vehicle and first clip the left and right side piece into guide parts - 10 -.
- Tighten nuts on fender connection => [ Fender bolts ] [1][2]Front Bumper Assembly Overview, From MY 2006.
- Tighten bolts - 12 - to wheel housing liner.
- Loosely thread in bolts - 1 -.
• Close hood and check cover for projection and recess.
• If necessary, check position of cover and tighten bolts - 4 -.
• Tighten bolt on support piece to 2 Nm=> [ Adjusting support piece ] [1][2]Front Bumper Assembly Overview, From MY 2006.
• Bumper cover, removing and installing => [ Front Bumper, from MY 2006 ] [1][2]Front Bumper, Assembly Overview.
• Crossmember, removing and installing => [ Front Bumper Crossmember, Removing from Cover ] [1][2]Front Bumper Crossmember.
3 Guide piece
4 Screw
• 1 Nm
5 Brace for fender
6 Bumper crossmember
7 Support piece
• When turning adjustment screw, make sure mounting bracket raises.
• Before installing bumper cover, adjust support piece adjusting screw => [ Adjusting support piece ] [1][2]Front Bumper Assembly Overview, From MY 2006.
• Tighten adjustment screw to 2 Nm with a long Torx(R) wrench - T30 - through holes in cover - arrows -.
• To disassemble, drill off pop rivet heads.
8 Front spoiler
• Remove screws - 10 -.
• Slide spoiler back slightly out of bumper cover guides.
• Remove spoiler downward.
9 Expanding rivet
10 Screw
• 2 Nm
11 Spring nut
Air intake grille for S4
- Remove bolt - arrows -.
- Press air intake grille - 2 - on the inside of bumper cover - 2 - as shown toward rear out of locking mechanism.
- Remove air intake grille forward from bumper cover.