Seat Rail Covers, From October 2002

Front Seats

• From 06.2006, the usual wiring harness routing to connector station under front seat. Refer to => [ Connectors, Disconnecting ] Front Seats has been replaced with modular wiring routing => [ Modular Wiring Routing Assembly Overview, from June 2006 ] Front Seats.

• The modular wiring routing has not been implemented for all countries.

• Check version of front seat and of vehicle and perform repairs accordingly.

• Note the two possible versions of the modular wiring routing, Modular Light or Modular. Refer to => [ Modular Wiring Routing Versions ] Front Seats.

Seat Rail Covers, from October 2002





1 Front Seat

2 Rear Seat Rail Covers (Qty. 2)

• Removing

- Drive front seat - 1 - to center position.

- Remove seat.

- Pry out seat rail cover - 2 - from beneath or - 3 - on the inside.

- Pry out seat rail cover on the outside.

- Pull off seat rail cover - 2 - or - 3 - as straight as possible.

• Installing

To install, perform the steps used in removal in reverse order.

3 Front Seat Rail Covers (Qty. 2)