Torsen Housing and Differential, Removing and Installing

Torsen Housing and Differential, Removing and Installing - 6 Spd. Manual Transmission 0A3 All Wheel Drive

Note:
^ Removal can also be carried out with transmission installed.





1 - Torsen housing

^ With or without vibration dampener, depending on version

2 - Bolt -24 Nm

^ Qty. 6

3 - Plate spring

^ Installation position: The inner diameter camber faces toward flange shaft in torsen housing

4 - Adjustment shim

^ Determine thickness.

5 - Spring

^ Place on flange shaft in torsen housing

6 - O-ring

^ Always replace
^ Coat with transmission fluid
^ Insert in surrounding groove in transmission cover

7 - Torsen differential

^ Service by manufacturer only
^ Torsen differential bearing, servicing

8 - Transmission

^ Secure at assembly bracket





Torsen housing, removing

- Place oil receptacle underneath transmission.
- Drain gear oil.
- Remove screws - arrows - and remove torsen housing.





Plate spring and shim, inserting in torsen housing

- Place plate spring - B - in torsen housing - A -.

^ Plate spring installation location: The inner diameter camber faces toward flange shaft in torsen housing.

Note:
^ Redetermine thickness of shim - C -.

- Place shim - C - on plate spring - B -.
- Place spring - D - on flange shaft in torsen housing.





Torsen housing, installing

- Coat new O-ring with transmission fluid and insert in surrounding groove in transmission cover.
- Place torsen housing on transmission cover.
- Tighten bolt - arrow - to 24 Nm.
- Top off transmission fluid and check transmission fluid level in manual transmission.