Front Standard Seat Backrest, Removing and Installing

Front Standard Seat Backrest, Removing and Installing

Special tools, testers and auxiliary items required







- Torque wrench V.A.G 1331







- Engine and transmission holder VAS 6095







- Fixture for seat repair VAS 6136

CAUTION: Observe safety precautions for work on airbags.







1 - Fastening strip
2 - Backrest

Removal
- Remove seat.
- Mount the fixture for seat repair VAS 6136 on the engine and transmission holder VAS 6095.
- Attach the front seat to the fixture for seat repair VAS 6136.
- Remove backrest adjustment wheel.
- Remove seat height adjustment handle.
- Remove side trim on sill side.
- Remove side trim on tunnel side.
- Disengage retaining strip - 1 - from seat pan - 8 -.
- Disconnect connectors and disconnect cables from spring mat.
- Remove screws - 5 - (4x).
- Tip backrest - 2 - forward on seat.
- Push cushion aside and carefully disconnect wiring harness - 3 - from seat pan - 8 -.
- Remove backrest - 2 -.

Installing
- Installation is reverse of removal. When doing so, note the following:
- If backrest adjustment wheel is too loose after installation, replace wheel.
- Secure tabs - 7 - (4x) on footwell cover to spring mat of seat pan.

3 - Cable harness
4 - Fastening strip
- Qty. 2

5 - Screw, self-locking
- Tightening torque 20 Nm
- Qty. 4
- Replace
- Threaded holes for screws must always be cleaned (for example, with thread cutter)

6 - Support
7 - Tab
- Qty. 4

8 - Seat pan







1 - Side airbag connector
- Only on vehicles without modular wiring routing through 08.05
- Press in catches on connectors - 4 -, - 5 - and - 6 - on left and right and disconnect connectors.
- Disconnect harness connector of side airbag - 1 -.
- Disconnect clip - 2 -.
- Loosen wires at cable tie clips - 3 -.

2 - Clip
3 - Cable tie clips
4 - Harness connector of side airbag Ground (GND)
5 - Backrest heater connector
6 - Four-way lumbar support connector







Side airbag connector, vehicles without modular wiring routing through 08.05, disconnecting

- Press catch - 1 - in direction of arrow and disconnect connector for side airbag - 2 -.