Needle Bearing on Dual Mass Flywheel, Pulling Out and Driving In

Needle Bearing on Dual Mass Flywheel, Pulling Out and Driving In

Special tools, testers and auxiliary items required

• Centering Mandrel (3176)

• Bearing Driver (3264)

• Depth Gauge (VAS 6082)

• Internal Puller (Kukko 21/2)

• Counter-Support (Kukko 22/1)

Procedure

• Transmission removed.

- Remove clutch pressure plate.

- Measure the depth - dimension x - that the needle bearing is driven into the dual-mass flywheel and note this for later re-installation.





- Pull out needle bearing using Internal Puller ( Kukko 21/2) and Counter-Support (Kukko 22/1).





• The plastic ring in the dual-mass flywheel is affected by impacts. If plastic ring is damaged, the dual-mass flywheel must be replaced.

- Drive needle bearing into dual-mass flywheel using Bearing Driver (3264).





- Using the backside of the Centering Mandrel ( 3176), press the needle bearing further in until the previously measured depth is achieved.





- Afterwards, verify the depth - dimension x - that the needle bearing is driven into the dual-mass flywheel.





- Install clutch pressure plate.