Ribbed Belt

Ribbed Belt

Removing

- Open the quick-release fasteners - 1 -, remove the screws - 2 - and then remove the noise insulation.





• Before removing the ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction will damage the ribbed belt.

- To release ribbed belt tension, swing tensioner in direction of - arrow -. Use a lever with 3/8" drive for this.





• Ensure lever axle is long enough so that it can be inserted completely in the tensioner.

• "Stahlwille 425QR" is a suitable lever.

- Remove ribbed belt.

- Release the tensioner unit

Installing

- Place ribbed belt over belt pulley in the specified sequence.





1. Generator

2. Ribbed belt

3. Idler roller

4. Vibration damper

5. Tensioning roller

• When installing the ribbed belt, make sure it is seated correctly on the pulleys.

The rest of installation is in reverse order of removal, note the following:

- Start engine and check belt running.