Selector Rod, Connecting Rod and Push Rod Assembly Overview

Selector Rod, Connecting Rod and Push Rod Assembly Overview

• Lubricate mounting areas and slide surfaces with Grease (G 000 450 02).





1 Ball socket

• to remove, bend peening on selector rod => [ (Item 19) Selector rod ]

2 Washer

3 Bushing

• to remove, remove retaining clip => [ (Item 9) Retaining clip ]

4 Boot

5 Transmission shift lever

6 Nut - 20 Nm

7 Bolt, 20 Nm

8 Connecting rod

• to remove, remove retaining clip => [ (Item 9) Retaining clip ]

9 Retaining clip

10 Bolt, 40 Nm

11 Push rod

• with screw and washers

12 Internal hex bolt - 23 Nm

13 Washer

14 Shift lever support

• Removing and installing => [ Selector Mechanism ] Selector Mechanism

15 Boot tensioning ring

16 Boot

• when removing, carefully remove from selector and push rod

• when installing, place on markings on selector rod and push rod

17 Internal hex bolt - 23 Nm

18 Clamping piece

19 Selector rod

20 Selector rod/shift lever CV joint

21 Nut - 10 Nm

22 Ball pin