High Beam Headlamp, Replacing Bulb

High Beam Headlamp, Replacing Bulb

Removing

- Turn light switch to position "0".

CAUTION!
• Switch off all electrical consumers.

• Switch ignition off and remove ignition key.

- Remove screws - arrows -.





- Remove Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 (N80) - 1 - at air duct.

- Remove air duct - 2 -.

- Release retaining clip - arrow - and detach housing cover for high beam/parking lamps from headlamp housing.





- Remove bulb - 1 - from spring clips - arrows -.





- Disconnect electrical connection - 2 - at high beam headlamp bulb.

Installing

Install in reverse order of removal, noting the following:

CAUTION!
• Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.

• When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.

- Insert bulb into housing.

- Position bulb at lower spring clip.

- Push bulb beyond resistance of upper spring clips into housing.

- Plug in connector and close housing cover.

- Secure housing cover with retaining clip.