Wheel Bearing With Wheel Bearing Housing (Steel) All Wheel Drive
Wheel bearing (with wheel bearing housing (steel) installed - all wheel drive), removing and installing
Special tools, testers and auxiliary items required
^ Engine/transmission jack V.A.G 1383 A with universal transmission mount V.A.G 1359/2
^ Foot pump with high pressure hose V.A.G 1389 A/1
If available in shop, hand pump V.A.G 1389/1 can also be modified for use as a foot pump.
To do so, use conversion kit V.A.G 1389/3.
Special tools, testers and auxiliary items required
^ Wheel bearing tool V.A.G 1459B
^ Hollow piston cylinder HKZ-15 with hydraulic thrust piece E-0-204-T
^ Tie bolt E-0-217+218
^ Special nut E-8-214
^ Press piece E-5
^ Supplementary set V.A.G 1459 B/2
^ Bell E-40
^ Press piece E-43
^ Thrust sleeve E-44-1
- Remove brake caliper, brake disc and brake disc cover.
- Remove drive axle.
Place engine/transmission jack V.A.G 1383 A underneath (danger of accident from falling parts when removing the wheel hub and the wheel bearing).
Wheel hub, pulling out
- Attach bell - 1 -, hollow piston cylinder - 2 - with tie bolt, and special nut - 3 -.
- Remove wheel hub by operating pump while holding tool securely.
1 - Bell E-40
2 - Hollow piston cylinder HKZ-15
3 - Special nut E-8-214 and tie bolt
Wheel bearing, pulling out
- Attach pressure piece - 1 - with collar to bearing, pressure sleeve - 2 - with four tiered interior diameters to wheel bearing housing, hollow piston cylinder - 3 - with tie bolt and special nut - 4 -.
- Operate pump and remove wheel bearing.
1 - Thrust piece E-5
2 - Thrust sleeve E-44-1
3 - Hollow piston cylinder HKZ-15
4 - Special nut E-8-214 and tie bolt
Wheel bearing, pressing in
Installed location: Larger internal diameter of wheel bearing faces outward.
- Put wheel bearing - 1 -, pressure piece - 2 - (put collar into bearing), and hollow piston cylinder - 3 - with tie bolt on wheel bearing housing.
- Attach pressure piece - 4 - with angles toward wheel bearing housing and special nut - 5 - from inside.
- Press wheel bearing in by operating the pump.
1 - Wheel bearing
2 - Thrust piece E-14-1
3 - Hollow piston cylinder HKZ-15
4 - Thrust piece E-43
5 - Special nut E-8-214 and tie bolt
Wheel hub, pressing in
- Put wheel hub - 1 - and hollow piston cylinder - 2 - with tie bolt onto wheel bearing.
- Attach pressure piece - 3 - with collar to special nut - 4 - from inside.
- Press in hub by operating the pump.
1 - Wheel hub
2 - Hollow piston cylinder HKZ-15
3 - Thrust piece E-5
4 - Special nut E-8-214 and tie bolt
Installation is in reverse order of removal.
- Install drive axle.
- Install brake caliper, brake disc and brake disc cover.