Wheel Bearing Housing (Steel)

Part V, wheel bearing housing (steel) - all wheel drive





1 - Wheel bearing housing

^ Vehicles with all-wheel drive

2 - Wheel bearing

^ Removing and installing with wheel bearing housing removed
^ Removing and installing in vehicle

3 - Wheel hub

^ Removing and installing with wheel bearing housing removed
^ Removing and installing in vehicle

4 - Collar bolt

^ Always replace
^ Tighten to 200 Nm plus an additional 180 degrees turn
^ Tighten to 200 Nm, if vehicle is raised, only tighten with additional turn when vehicle is on floor
^ If vehicle is resting on floor, do not loosen more than 90 degrees

5 - Drive axle

^ Servicing (with inner joint 100 mm dia.)
^ Servicing (with inner joint dia. mm 108)

6 - Speed sensor

^ Wire routing

7 - Hex socket head bolt, 10 Nm
8 - Washer
9 - Nut, self-locking

^ Always replace

10 - Strut

^ Observe installed location
^ Note different vehicle versions, see vehicle data plate.
^ Faulty struts must be vented and emptied before disposal
^ Check removed strut

11 - Combi-bolt, 36 Nm
12 - Combi-bolt

^ Always replace
^ Tighten to 150 Nm plus an additional 90 degrees turn
^ Tighten bolts only in curb weight position