Right Coolant Fan 2

Right Coolant Fan 2

Removing

• All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.

- Bring lock carrier into service position. Refer to => [ Lock Carrier, Moving into Service Position ] Lock Carrier, Moving Into Service Position.

- Disconnect electrical harness connector - arrow -.





- Move wiring harness to coolant fan clear.

- Remove bolts - 1 -.





- Turn coolant fan in direction of - arrow - and remove it.

Installing

Installation is in reverse order of removal, note the following:

• During installation, all cable ties must be re-installed at the same location.

- Install lock carrier with attachments. Refer to =>
Radiator Support Radiator Support

- Place torque support on rubber buffer for torque support and tighten bolts - arrows -.





- Install front bumper cover.

- Check headlight adjustment.

Tightening Specifications