Navigation System With CD Drive Control Module, MMI Basic Plus

Navigation System with CD Drive Control Module, MMI Basic Plus

Special tools, testers and auxiliary items required

• Radio Removal Tool (T10057)

• Protective cap for cable connector (VAS 6223/9)

The navigation system with CD drive control module (J401) is located in the glove compartment.

- Switch off all electrical consumers.

- Remove the key.

If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine in the Vehicle Diagnostic Tester.

Removing

- Insert two clips of (T10057) into release slots of navigation system with CD drive control module until they engage. Points on the grip eyelets of tool face outward.






- Pull navigation system with CD drive control module out of mounting frame.

- Disconnect all connectors from the navigation system with CD drive control module.

- Connect the (VAS 6223/9) - 1 - to the connector for the MOST-Bus - 2 -.






- Remove (T10057) by pressing locking tabs on navigation system with CD drive control module.

Installing

- Connect harness connectors.

- Slide the navigation system with CD drive control module in until it engages in mounting frame.

Overview, refer to => [ Navigation System Overview, through 10.2008 ] Navigation System Overview, Through 10.2008