Radiator Grille

Radiator Grille

Removing






Proceed as follows:

- Remove the bumper cover. Refer to => [ Bumper Cover ] Bumper Cover.

- Remove the impact absorber. Refer to => [ Impact Absorber ] Impact Absorber.

- Remove the bolts - 3 -.

- Free up the parking aid sensor electrical wiring harness on the radiator grille, if applicable, by disconnecting the cable ties - 1 -.

- Remove the electrical connector - 2 - from the bracket.

- To do this, press the release in the direction of - arrow A - and remove the electrical connector - 1 - from the bracket - 2 - in the direction of - arrow B -.






Audi S5:






- Remove the bolts - arrows -.

- Remove the reinforcing bars - 1 through 3 -.

All:






- Disconnect the electrical connectors - 5 and 6 - - 6 - on the parking aid sensors.

- Remove the bolts - arrows - and the radiator grille - 4 - from the bumper cover.

- If necessary, removing the parking aid sensor mount by releasing the clips and removing the mount.

Installing

• Tightening specifications, refer to => [ Radiator Grille Overview ] Radiator Grille Overview and => [ Audi S5 Bumper Cover ] Bumper Cover Overview.

Install in reverse order of removal. Note the following:

- Install the impact absorber. Refer to => [ Impact Absorber ] Impact Absorber.

- Install the bumper cover. Refer to => [ Bumper Cover ] Bumper Cover.