Backrest Cover

Backrest Cover

• Removal and installation can be done with seat installed.

• Removing and installing a standard front seat is described. Removal and installation on the other seat versions is similar.

• The illustration shows a backrest cover without a storage net.

• The storage net cannot be removed from the backrest cover and can only be replaced together with the backrest cover.

Removing






Wear protective gloves to avoid injury from burrs that may be on the backrest cover.

- Disengage the lower side hooks - 3 - (quantity: 2) on the backrest cover - 2 -.

1 Backrest frame trim

- Press the backrest cover - 1 - toward the center of the seat in the direction of- arrow A -.






- Remove the backrest cover back in the direction of - arrow B -.

- Do the same on the opposite side.

- Disengage the sides of the backrest cover - 2 - - arrows A, B, E and F -.






- Reach behind the backrest cover - 1 - and remove the right side from the backrest - 2 -.






- Do the same to the opposite side of the backrest cover - 1 -.

- Loosen the side retaining hooks - 3 - or - 5 - => [ Overview of Backrest Cover Mounting Points ] Backrest Cover and Backrest Frame Trim Overview.

- Remove the backrest cover - 1 - further and bend it until the upper hooks - 2 - => [ Overview of Backrest Cover Mounting Points ] Backrest Cover and Backrest Frame Trim Overview disengage from the backrest frame.






• The illustration does not show the upper hooks.

- Tip the backrest cover - 1 - back slightly.

- Press the backrest cover - 1 - down in the direction of - arrow A -.






- Lift the backrest cover in the direction of - arrow B - and remove it from the backrest frame.

Installing






Install in reverse order of removal. Note the following:

- First slide the upper hooks - 2 - => [ Overview of Backrest Cover Mounting Points ] Backrest Cover and Backrest Frame Trim Overview under the top backrest frame cross panel.

- Tilt the backrest cover down and engage the side retaining tabs - 3 - and - 5 - and the lower hooks - 4 -.

- Make sure the side retaining tabs - 3 - and - 5 - engage with the backrest frame trim correctly and the lower hooks - 4 - slide over the backrest frame trim seats.

- Press the backrest cover - 1 - firmly into the areas marked with circles in the direction of the backrest.






- Check the retainers for secure seating and try to pull the lower part of the backrest cover off.

- The backrest cover is engaged properly if it cannot be pulled off.