Diagram 43/4 (Tracks 29-42)

IMPORTANT NOTE:
This manufacturer uses "Track" style wiring diagrams.
For information on how to use these diagrams effectively, please refer to Diagram Information and Instructions. Diagram Information and Instructions


ESP sensor unit, ESP sensor unit 2, ABS control module, Active steering control module, ABS hydraulic pump





ws = white
sw = black
ro = red
br = brown
gn = green
bl = blue
gr = grey
li = lilac
ge = yellow
or = orange
rs = pink

G200 - Transverse acceleration sensor Bosch 8.1 ABS/Electronic Stabilization Program Component Overview

G202 - Rotation rate sensor Bosch 8.1 ABS/Electronic Stabilization Program Component Overview

G251 - Longitudinal acceleration sensor Bosch 8.1 ABS/Electronic Stabilization Program Component Overview

G419 - ESP sensor unit Bosch 8.1 ABS/Electronic Stabilization Program Component Overview

G536 - ESP sensor unit 2 Bosch 8.1 ABS/Electronic Stabilization Program Component Overview

J104 - ABS control module

J792 - Active steering control module

T4ab - 4-pin connector

T6m - 6-pin connector

T10h - 10-pin connector Locations

T38a - 38-pin connector Locations

V64 - ABS hydraulic pump

(368) - Ground connection 3 (in main wiring harness)

(370) - Ground connection 5 (in main wiring harness)

(639) - Ground connection on left A-pillar

(B135) - Positive connection 1 (15a) (in interior wiring harness)

(B663) - Suspension sensor CAN bus high connection (in main wiring harness)

(B664) - Suspension sensor CAN bus low connection (in main wiring harness)

* - Special equipment

*2 - Only for vehicles with all wheel drive

*3 - Running change

*4 - Omitted as a running change

Previous Diagram 43/3 (Tracks 15-28)

Next Diagram 43/5 (Tracks 43-56)