Fuel Pressure Sensor: Service and Repair

Fuel Pressure Sensor

Removing

- Remove intake manifold.

- Open the high pressure line union nut at the fuel rail.

- Remove the Fuel Pressure Sensor (G247) bolt - 1 -.





• The installation location may differ on vehicle from MY 2009.

- Remove the Fuel Pressure Sensor (G247) with the high pressure line.

• Do not change the angles of the high pressure lines.

Installing

- Tighten the Fuel Pressure Sensor (G247).

• Tightening Specifications. Refer to => [ Component Location Overview ] Component Location Overview

• The high pressure line connectors - arrows - must not be damaged.

• Do not bend the high pressure line to a different angle.

- Tighten the high pressure line union nut by hand.

- Make sure the high pressure line is free of tension.

- Tighten the 17 mm union nut on the high pressure line with the Torque Wrench (V.A.G 1331) and 17 mm Socket Insert (V.A.G 1331/6).





Further installation is in reverse order.

- Install intake manifold.