Battery Monitoring Control Module

Battery Monitoring Control Module

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Contact Corrosion.

Removing

- Switch off ignition and remove ignition key.

2-door





- Lift the luggage compartment floor and engage it on the body.

- Remove the nut - 1 - and the tool kit cover - 2 -.

- Remove the tool kit mount.

5-door





- Remove the luggage compartment floor panel cover.

- Remove the nut - 1 - and the tool kit cover - 2 -.

- Remove the subwoofer, if applicable.

Negative terminal cover - version I





- Pull the cover - 2 - over the negative terminal up slightly - arrow -.

- Loosen the nut several turns and remove the ground cable - 1 - from the battery terminal.

- Disconnect the electrical connector - 3 -.

- Remove the nut - 6 - and remove the ground wire - 4 - with the battery monitoring control module (J367) - 4 -.

Negative terminal cover - version II





- Open the cover - 2 - over the battery negative terminal.

- Loosen the nut several turns and remove the ground cable - 1 - from the battery terminal.

- Disconnect the electrical connector - 3 -.

- Remove nut - 6 - and ground cable - 5 - with the battery monitoring control module (J367) - 4 -.

Installing

• Torque specifications for 2-door, refer to => [ Battery, 2-Door Assembly Overview ] Battery, 2-Door Assembly Overview, 5-door, refer to => [ Battery, 5-Door Assembly Overview ] Battery, 5-Door Assembly Overview.

Install in reverse order of removal, observing the following:

- Install the subwoofer, if applicable.

- Connect battery => [ Connecting ] Battery, Disconnecting and Connecting.