Pump

Pump

Special tools, testers and auxiliary items required

• Hex Ball Socket (T10058)

• Drip Tray

• Observe general repair notes, refer to => [ Repair Information ] Repair Information.

• Follow all safety precautions, refer to => [ Safety Precautions and Test Procedures ] Safety Precautions and Test Procedures.

Removing

- Place the vehicle on a hoist.

• Turn off the ignition.

- Place the drip tray under the rear final drive.

- Disconnect the connector - 1 - from the All Wheel Drive (AWD) pump (V415) - 2 -.






- Remove the 4 AWD pump bolts on the hydraulic control unit using the (T10058).

- Carefully remove the AWD pump - 2 - while paying attention to the adapter - item 4 - => [ (Item 4) Adapter ] Overhaul in the hydraulic pump.

• The adapter could fall out when removing the AWD pump.

• Insert the adapter into the recesses in the hydraulic pump before installing the AWD pump.

Installing

• The hydraulic pump - A - is installed inside the hydraulic control unit in its Installed position; assembling the hydraulic pump. Refer to => [ Assembling the Hydraulic Pump ] Overhaul.






• The adapter - B - is installed into the recesses in the hydraulic pump.

• The new O-ring - D - is installed on the AWD pump.

- Install the AWD pump and the shaft - C - into the adapter - B -.

- Tighten the four bolts on the AWD pump - 2 - diagonally => [ (Item 1) Bolt ] Overhaul.






- Connect the connector - 1 - to the AWD pump.

- Fill the ATF in the rear final drive. Refer to => [ ATF in Rear Final Drive 0BF and 0BE, Filling ] ATF In Rear Final Drive 0BF and 0BE, Filling.