Ribbed Belt Drive Assembly Overview

Ribbed Belt Drive Assembly Overview





1 22 Nm

2 22 Nm

3 Tensioning device for ribbed belt

4 22 Nm

5 Generator

6 M8, 22 Nm; M10, 46 Nm

7 Alignment bushing

• For generator bracket

• 2 pieces

8 Generator bracket

9 10 Nm

10 Idler roller holder

11 Vibration damper

• Removing and installing, refer to => [ Vibration Damper ] Service and Repair

12 Bolt

• Replace

• Only use original equipment bolts, Bolt class 12.9

• Insert bolts that are not self-locking with locking compound; Locking compound.

• Tightening specification and sequence => [ Tighten the vibration damper bolts in 4
steps: ] Service and Repair

13 Idler roller for ribbed belt

14 22 Nm

15 Cap

16 Ribbed belt

• Check for wear

• Do not kink

• Before removing, mark direction of rotation using chalk or felt-tip marker A reversed turning direction can cause damage to the ribbed belt under operating conditions

• Removing and installing, refer to => [ Ribbed Belt ] Ribbed Belt

• When installing the ribbed belt, make sure it is seated correctly on the pulleys

17 Threaded bushing